Configuring a controller using Express Setup

When you select a connection type to a new site and immediately save, the system prompts you to use the Express Setup tool to define the device. You can also launch this tool by selecting a controller and clicking the Express Setup in the Controller dialog.

  1. From the Controller window, select an undefined controller.
  2. Under the General tab, select the Controller type .
  3. Click Save and a message box displays the following message: Do you want to use the Express Setup program to configure the associated devices. Click Yes to continue with the Express Setup .
    • If you click on No, you can return to the express setup by clicking Express Setup .
      Note: The KT-300 is a 2-door system and the KT-400 is a four-door system.
  4. Click Both readers are installed on the same door, if applicable (not for a KTES). When two readers are installed on the same door, the REX contact option is disabled.
  5. Click the Advanced button to define the other devices, such as doors, inputs, relays, and outputs.
    Note: Components are listed in the left-hand pane. The related tabs are displayed in the middle of the window. When you select a component, its default name, number, and default settings are displayed in the language section. Select a component to enable its tab. Components that are assigned are gray and cannot be modified at this stage. However, you can later modify any component description in its definition menu (Devices>Controller/Door/Relay/Input/Output).