Configuring Specific Controller Parameters

  1. Click the Controller tab (KT-100, KT-200, KT-300, KT-400 or KT-1/KT-2) from the Controller window.
  2. Enter the controller serial number in the Serial number field. Usually, the number is found on the controller label. The field is defined to accept only numeric characters, except for the first character which may be an a or A. If a lower case character is entered, the system converts it to a capital letter.
  3. For KT-400 only:
  4. For KT-300 only:
  5. For KT-200 only:
  6. Enter the Wait for second access card delay. The maximum time allowed is 2 minutes and 7 seconds. This feature is useful for secured areas where two cards are required to access a secured door. If the value entered is greater than the maximum allowed, the system will use the existing value.
  7. In the Keypad escape key drop-down list, choose a keypad escape key if applicable. This feature is associated with PIN numbers. When a user enters a wrong number, he/she may press the escape key and re-enter the PIN, without incrementing the number of attempts.
  8. In the EOL resistor (5.6K) drop-down list, select the resistor type used with your system. By default, this choice is set to None . This feature is used as a supervision device for all inputs. In fact, if this feature is enabled and if an input is disconnected, an alarm message is generated and sent to the Alarm message desktop (or other desktop configured to receive such events).
  9. Select a value from the RS-485 baud rate list.
  10. In the Reader template list, click the more options button to select a reader template. Selecting a template ensures any reader connected to the contoller inherits the template properities.
  11. Click the Save button.